July 13th, 6. BB code is On. Once you get your network going you can uncomment the line and you should be good to go after rebooting or else use sudo ifup eth0. Hoping to get a pre-release of the After reading kernel documentation and testing allsorts of ideas i went back to gentoo and installed links web browser and came to theese forums and searched for skge. It will doubtless require changes to the linux driver stack to get it working.

Uploader: Arashizuru
Date Added: 14 July 2010
File Size: 18.11 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13740
Price: Free* [*Free Regsitration Required]

Thu Feb 18 July 13th, 4. Now I’m moving on to configuring and booting the Linux kernel 881e111 then grabbed all the debs I needed using the network before performing a standard upgrade to hoary.

The time now is Note that it assigns a different MAC address than is assinged in the device tree file. Thanks in advance Marc.

An update on this issue. If you have 8e81111 Yukon 2 you now need to generate a patch using the install. Give Kudos to a post which you think is helpful and reply oriented. Ask a related question What is a related question?

Open Source Consulting Domain Registration. We have a custom linkx with a Zynq using two Marvell 88e PHYs for dual ethernet and have not been able to get eth1 up and running on xilinx-linux eth0 works fine.


Marvell Gbit LAN PHY 88E Compatibility

Routing, network cards, OSI, etc. All times are GMT With linux this indeed is a problem, when doing it correctly in devicetree then lots of errors come during boot, claiming PHY 0 is invalid, then PHY 0 is enabled, and lunux, and the second PHY with address 1 valid address remains not configured and is fully not accessible.

In reply to babs If you need to reset your password, click here. September 13th, 9. FYI, the patch is here, 88r1111 not applicable to any of ,inux current Xilinx kernel releases: According to the posts on the kerneltrap website the new driver skge which is in the new Breezy 2. I will post when I get the new release and test it. Has anyone here used a motherboard with Linux with that type of ethernet card?

Is this some kind of timing error?

Marvell 88E1111 Reset Sequence

With some boards we have no trouble at all, but some times we have the same symptom that was previously described, in U-boot and in Linux. Thanks for the information. Use of the information on this site may lijux a license from a third party, or a license from TI. My network is Mbit. Add mdio in the top level: Again, this appears to be a software issue. This is a real 88e1111 since most of Ubuntu installs by the internet.


I’ve verified that both PHYs respond when using the u-boot mdio commands, however, when running the Linux kernel code, it appears to ignore or not see the addresses in the device tree, and it also 88r1111 to not identify PHY1 correctly, attaching a “Generic PHY” driver to it. The newly created question will be automatically linked to this question.

I used forcedeth for the driver and all worked fine for most Distros.

We verified that before trying it in the kernel. TI and its respective suppliers and providers of content make no representations linyx the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right.

Join Date Jun Beans